The overview of wind power foundation mold is customized based on the size of wind power facilities. Because the equipment of wind power generation is relatively large, the foundation at the bottom needs to be done well, and the depth and diameter need to be well controlled. Especially the diameter is often relatively large, and the processing time is longer when making. This kind of mold is to help the wind turbine to process, During production, the steel bar with the specification of more than 5mm must be used to make the mold. If the steel plate is too thin, the compressive effect of the mold will be reduced. Moreover, for the wind power foundation mold, the overall length will exceed 20m. Pouring a large amount of mud will make the mold bear too much pressure, Naturally, the mold needs to be processed and manufactured with high-specification materials. Only in this way can the normal use of mold forming be ensured. When the mold is used, it needs to be cast on site. Naturally, a large number of tools, including processing equipment, are needed. Multiple workers and machines assemble the mold at the same time, Some tools also need to be used to reinforce the outside of the wind power foundation mold.